Manualshelf

Users Guide

ManualsBrandsDell ManualsAccess PlatformsSmartFabric OS10 Documentation
251252253254255256257258259260
Table Of Contents
switchport access vlan 1
negotiation off
flowcontrol receive on
OS10(conf-if-eth1/1/50)# negotiation on
OS10(conf-if-eth1/1/50)# show configuration
!
interface ethernet1/1/50
no shutdown
switchport access vlan 1
negotiation on
flowcontrol receive on
OS10(conf-if-eth1/1/50)# negotiation auto
OS10(conf-if-eth1/1/50)# show configuration
!
interface ethernet1/1/50
no shutdown
switchport access vlan 1
flowcontrol receive on
OS10(conf-if-eth1/1/50)#
OS10(conf-if-eth1/1/50)# negotiation on
OS10(conf-if-eth1/1/50)# show configuration
!
interface ethernet1/1/50
no shutdown
switchport access vlan 1
negotiation on
flowcontrol receive on
OS10(conf-if-eth1/1/50)# no negotiation
OS10(conf-if-eth1/1/50)# show configuration
!
interface ethernet1/1/50
no shutdown
switchport access vlan 1
flowcontrol receive on
OS10(conf-if-eth1/1/50)# do show interface ethernet 1/1/50
Ethernet 1/1/50 is up, line protocol is up
Hardware is Eth, address is e4:f0:04:3e:2d:86
Current address is e4:f0:04:3e:2d:86
Pluggable media present, QSFP28 type is QSFP28 100GBASE-CR4-2.0M
Wavelength is 64
Receive power reading is not available
Interface index is 112
Internet address is not set
Mode of IPv4 Address Assignment: not set
Interface IPv6 oper status: Disabled
MTU 1532 bytes, IP MTU 1500 bytes
LineSpeed 100G, Auto-Negotiation on
支持的版本 10.2.0E 或更高版本
port mode Eth
将 Z9264F-ON QSFP28 端口组配置为在以太网模式下运行，并在激活的接口上使用指定的速度。
语法
port node/slot/port mode Eth port-mode
参数
● node/slot/port — 输入接口类型详情。
● mode Eth — 在以太网模式下配置端口组并将速度设置为：
○ 100g-1x — 将端口重置为 100GE 模式。
○ 50g-2x — 将一个端口拆分为两个 50GE 接口。
○ 40g-1x — 将端口设置为 40GE 模式，以便与 QSFP+40GE 收发器配合使用。
○ 25g-4x — 将一个端口拆分为四个 25GE 接口。
○ 10g-4x — 将一个端口拆分为四个 10GE 接口。
默认 100g-1x
258 接口