Users Guide

Usage Information
The speed command is supported only on the Management and Fibre Channel interfaces. This command is not
supported on Ethernet interfaces.
• When you manually congure the management port speed, match the speed of the remote device. Dell EMC
highly recommends using auto-negotiation for the management port.
•
The no version of this command resets the port speed to the default value auto.
Example
OS10(conf-if-ma-1/1/1)# speed auto
Supported Releases 10.3.0E or later
switchport access vlan
Assigns access VLAN membership to a port in L2 access or trunk mode.
Syntax
switchport access vlan vlan-id
Parameters vlan vlan-id — Enter the VLAN ID number (1 to 4093).
Default VLAN 1
Command Mode INTERFACE
Usage Information This command enables L2 switching for untagged trac and assigns a port interface to default VLAN 1. Use this
command to change the assignment of the access VLAN that carries untagged trac. You must create the VLAN
before you can assign an access interface to it. The no version of this command resets access VLAN membership
on a L2 access or trunk port to VLAN 1.
Example
OS10(conf-if-eth1/1/3)# switchport mode access
OS10(conf-if-eth1/1/3)# switchport access vlan 100
Supported Releases 10.2.0E or later
switchport mode
Places an interface in L2 access or trunk mode.
Syntax
switchport mode {access | trunk}
Parameters
• access — Enables L2 switching of untagged frames on a single VLAN.
• trunk — Enables L2 switching of untagged frames on the access VLAN, and of tagged frames on the VLANs
specied with the
switchport trunk allowed vlan command.
Default
access
Command Mode INTERFACE
Usage Information
• If an IP address is assigned to an interface, you cannot use this command to enable L2 switching — you must
rst remove the IP address.
• The access parameter automatically adds an interface to default VLAN 1 to transmit untagged trac. Use the
switchport access vlan command to change the access VLAN assignment.
•
The trunk parameter congures an interface to transmit tagged VLAN trac. You must manually congure
VLAN membership for a trunk port with the switchport trunk allowed vlan command.
86 Interfaces