Users Guide

Assign Port Channel IP Address
OS10(config)# interface ethernet 1/1/1
OS10(conf-if-eth1/1/1)# ip address 1.1.1.1/24
OS10(conf-if-eth1/1/1)#
Remove or disable port-channel
You can delete or disable a port-channel.
1 Delete a port-channel in CONFIGURATION mode.
no interface port-channel channel-number
2 Disable a port-channel to place all interfaces within the port-channel operationally down in CONFIGURATION mode.
shutdown
Delete port-channel
OS10(config)# interface port-channel 10
OS10(conf-if-po-10)# no interface port-channel 10
Load balance trac
You can use hashing to load balance trac across the member interfaces of a port-channel. Load balancing uses source and destination
packet information to distribute trac over multiple interfaces when transferring data to a destination.
For packets without an L3 header, OS10 automatically uses the load-balancing mac—selection destination-mac command
for hash algorithms by default.
When you congure an IP and MAC hashing scheme at the same time, the MAC hashing scheme takes precedence over the IP hashing
scheme.
• Select one or more methods of load balancing and replace the default IP 4-tuple method of balancing trac over a port-channel in
CONFIGURATION mode.
OS10(config)# load-balancing
tcp-udp-selection TCP-UDP port for load-balancing configurations
ip-selection IPV4 load-balancing configurations
ipv6-selection IPV6 load-balancing configurations
mac-selection MAC load-balancing configurations
– tcp-upd-selection [l4–destination-port | l4–source-port] — Uses the Layer 4 destination IP address, or
Layer 4 source IP address in the hash calculation.
– ip-selection [destination-ip | source-ip | protocol | vlan-id | l4–destination-port | l4–
source-port]
— Uses the destination IP address, source IP address, protocol, VLAN ID, Layer 4 destination IP address, or Layer
4 source IP address in the hash calculation.
– ipv6-selection [destination-ip | source-ip | protocol | vlan-id | l4–destination-port | l4–
source-port]
— Uses the destination IPv6 address, source IPv6 address, protocol, VLAN ID, Layer 4 destination IPv6 address,
or Layer 4 source IPv6 address in the hash calculation.
– mac—selection [destination-mac | source-mac] [ethertype | vlan-id] — Uses the destination MAC
address or source MAC address, and ethertype, or VLAN ID in the hash calculation.
Congure load balancing
OS10(config)# load-balancing ip-selection destination-ip source-ip
Interfaces
71