Users Guide

Usage Information The no version of this command removes the specied prex-list.
Example
OS10(config)# ipv6 prefix-list TEST seq 65535 permit AB10::1/128 ge 30
Supported Release 10.3.0E or later
mac access-group
Assigns a MAC access list to an interface.
Syntax
mac access-group access-list-name {in | out}
Parameters
• access-list-name — Enter the name of a MAC access list. A maximum of 140 characters.
• in — Apply the ACL to incoming trac.
• out — Apply the ACL to outgoing trac.
Default Not congured
Command Mode CONFIGURATION
Usage Information The no version of this command resets the value to the default.
Example
OS10(config)# mac access-group maclist in
OS10(conf-mac-acl)#
Supported Releases 10.2.0E or later
mac access-list
Creates a MAC access list to lter based on an MAC address.
Syntax
mac access-list access-list-name
Parameters access-list-name — Enter the name of a MAC access list. A maximum of 140 characters.
Default Not congured
Command Mode CONFIGURATION
Usage Information None
Example
OS10(config)# mac access-list maclist
Supported Releases 10.2.0E or later
permit
Congures a lter to allow packets with a specic IP address.
Syntax
permit [protocol-number | icmp | ip | tcp | udp] [A.B.C.D | A.B.C.D/x | any |
host ip-address] [A.B.C.D | A.B.C.D/x | any | host ip-address] [capture | dscp
value| fragment]
400 Access Control Lists