Users Guide

Change the access port membership in a VLAN by specifying the new VLAN. You must create the VLAN before you can assign the port in
Access mode to that VLAN. Use the no switchport access vlan command to reset to default VLAN.
1 Congure a port in INTERFACE mode.
interface ethernet node/slot/port[:subport]
2 Set the interface to Switchport mode as access in INTERFACE mode.
switchport mode access
3 Enter the VLAN number for the untagged port in INTERFACE mode.
switchport access vlan vlan-id
Congure port in access mode
OS10(config)# interface ethernet 1/1/9
OS10(config-if-eth1/1/9)# switchport mode access
OS10(config-if-eth1/1/9)# switchport access vlan 604
Show running conguration
OS10# show running-configuration
...
!
interface ethernet1/1/5
...
switchport access vlan 604
no shutdown
!
interface vlan1
no shutdown
...
Trunk mode
A trunk port can be a member of multiple VLANs set up on an interface. A trunk port can transmit trac for all VLANs. To transmit trac
on a trunk port with multiple VLANs, OS10 uses tagging or the 802.1q encapsulation method.
1 Congure a port in INTERFACE mode.
interface ethernet node/slot/port[:subport]
2 Change the Switchport mode to Trunk mode in INTERFACE mode.
switchport mode trunk
3 Enter the allowed VLANs on the trunk port in INTERFACE mode.
switchport trunk allowed vlan vlan-id
Congure port in trunk mode
OS10(config)# interface ethernet 1/1/6
OS10(conf-if-eth1/1/6)# switchport mode trunk
OS10(conf-if-eth1/1/6)# switchport trunk allowed vlan 108
View running conguration
OS10# show running-configuration
...
!
interface ethernet1/1/8
switchport mode trunk
switchport trunk allowed vlan 108
no shutdown
!
interface vlan1
no shutdown
180
Layer 2