Users Guide

pcieg3fw.bin 100%[===================>] 30.00K --.-KB/s in 0.001s
2020-08-12 06:37:32 (32.2 MB/s) - 'pcieg3fw.bin' saved [30720]
6. Enter the nputool -d -i command.
root@dellemc-diag-os:/etc/dn/diag# nputool -d -i
linux-user-bde:new probed device unit 0 dev_no 0 _ndevices 1
DMA pool size: 33554432
PCI unit 0: Dev 0xb873, Rev 0x01, Chip BCM56873_A0, Driver BCM56870_A0
sysconf_probe successful
global_sal_config successful
*** 1 BCM devices are detected
SOC unit 0 attached to PCI device BCM56873_A0
Loading M0 Firmware located at /etc/dn/diag/linkscan_led_fw.bin
Loading M0 Firmware located at /etc/dn/diag/custom_led.bin
*** unit 0: ports capable of limited speed range cut-thru
0:bcmi_xgs5_bfd_init: uKernel BFD application not available
Current mode is now ESW
Diag NPU initialization over
Enter 'exit' to exit out of bcm shell
Inside bcm shell
BCM.0>
The system enters the BCM shell.
7. Enter the pciephy fw load pcieg3fw.bin command.
BCM.0> pciephy fw load pcieg3fw.bin
0:soc_flash_init: Flash supported ID = 0x20
Opening file: pcieg3fw.bin
Updating PCIE firmware
......................................................................................
.................................. Done
PCIE firmware updated successfully. Please reset the system...
BCM.0>
8. Enter Exit to return to the DIAG OS prompt.
BCM.0> exit
root@dellemc-diag-os:#
9. Reboot the switch.
root@dellemc-diag-os:# reboot
PCIe firmware upgrade is complete. The system boots with OS10 Release 10.5.0.9.
38
Upgrade PCIe firmware from DIAG OS