Reference Guide

Congure VLAN
OS10(config)# interface vlan 10
OS10(conf-if-vl-10)# ip address 1.1.1.2/24
You cannot simultaneously use egress rate shaping and ingress rate policing on the same VLAN.
User-congured default VLAN
By default, VLAN 1 serves as the default VLAN for switching untagged L2 trac on OS10 ports in trunk or access mode. The default VLAN
is used for untagged protocol trac sent and received between switches, such as spanning-tree protocols. If VLAN 1 is used for data trac
for network-specic needs, recongure the VLAN ID of the default VLAN.
• Assign a new VLAN ID to the default VLAN in CONFIGURATION mode (1 to 4093).
default vlan-id vlan-id
In the show vlan output, an asterisk (*) indicates the default VLAN.
Recongure default VLAN
OS10# show vlan
Q: A - Access (Untagged), T - Tagged
NUM Status Description Q Ports
* 1 up A Eth1/1/1-1/1/25,1/1/29,1/1/31-1/1/54
OS10(config)# interface vlan 10
Sep 19 17:28:10 OS10 dn_ifm[932]: Node.1-Unit.1:PRI:notice [os10:notify],
%Dell EMC (OS10) %IFM_ASTATE_UP: Interface admin state up :vlan10
OS10(conf-if-vl-10)# exit
OS10(config)# default vlan-id 10
Sep 19 17:28:15 OS10 dn_ifm[932]: Node.1-Unit.1:PRI:notice [os10:trap], %Dell EMC (OS10)
%IFM_OSTATE_DN: Interface operational state is down :vlan1
Sep 19 17:28:16 OS10 dn_ifm[932]: Node.1-Unit.1:PRI:notice [os10:trap], %Dell EMC (OS10)
%IFM_OSTATE_UP: Interface operational state is up :vlan10
OS10(config)# do show vlan
Codes: * - Default VLAN, M - Management VLAN, R - Remote Port Mirroring VLANs
Q: A - Access (Untagged), T - Tagged
NUM Status Description Q Ports
1 down
* 10 up A Eth1/1/1-1/1/25,1/1/29,1/1/31-1/1/54
VLAN scale prole
When you scale the number of VLANs on a switch, use the VLAN scale prole so that less memory is consumed. Enable the scale prole
before you congure VLANs on the switch. The scale prole globally applies L2 mode on all VLANs you create and disables L3 transmission.
To enable L3 routing trac on a VLAN, use the mode L3 command.
1 Congure the L2 VLAN scale prole in CONFIGURATION mode.
scale-profile vlan
2 (Optional) Enable L3 routing on a VLAN in INTERFACE VLAN mode.
mode L3
After you upgrade OS10 from an earlier version with congured VLANs, if you congure the VLAN scale prole and enable L3 VLANs, save
the conguration and reload the switch to apply the scale prole settings.
Apply VLAN scale prole
OS10(config)# scale-profile vlan
OS10(config)# interface vlan 10
OS10(conf-if-vl-10)# mode L3
76
Interfaces