Users Guide

PTP system log message reference
This section lists the system log messages that are generated by the PTP process.
Table 38. PTP system log messages
System log message Severity Description Recommended action
%PTP_CLOCK_PHASE_LOCKED
: Clock servo is phase locked.
Informational Lock status of the clock is phase
locked with master. This means that
the offset with the master is within
the default range of +/- 1 micro
seconds. Lock status of the clock is
phase locked with master. This means
that the offset with the master is
within the default range of +/- 1 micro
seconds.
No action required.
%PTP_CLOCK_PHASE_LOCK_E
XITED: Clock servo is out of
phase lock.
Informational Lock status of the clock is out of
lock with master clock. This indicates
the loss of master clock or config
change. In the case of losing master
clock, clock runs either in holdover
mode or switch to other master. Lock
status of the clock is out of lock with
master clock. This indicates the loss
of master clock or config change. In
the case of losing master clock, clock
runs either in holdover mode or switch
to other master.
Check the network
connection if this loss of
master is not intended.
%PTP_PORT_ROLE_CHANGED:
Port role changed.
Informational Indicates the role of a specific PTP
port is changed to SLAVE.
No action required.
%PTP_PORTS_LIMIT_REACHED
: Ports limit reached.
Informational Number of configured ports reached
the system supported limit..
No action required.
%PTP_SLAVES_LIMIT_REACHE
D: Slaves limit reached.
Informational Number of configured unicast slaves
reached the system supported limit.
Number of configured unicast slaves
reached the system supported limit.
No action required.
%PTP_MASTERS_LIMIT_REACH
ED: Masters limit reached.
Informational Number of configured unicast masters
reached the system supported limit.
Number of configured unicast masters
reached the system supported limit.
No action required.
%PTP_SYSTEM_TIME_NOT_SE
T: System time is not set.
Informational Indicates that the system time is not
set currently as the clock is not phase
locked with master. System time will
be set when the clock is phase locked.
Indicates that the system time is not
set currently as the clock is not phase
locked with master. System time will
be set when the clock is phase locked.
No action required.
%PTP_SYSTEM_TIME_UPDATE
_STARTED: System time update
service is started.
Informational Indicates that the system time update
service is started and would update
the system time at regular intervals.
Indicates that the system time update
No action required.
39
PTP system log message reference 63