Users Guide

PIM system log message reference
This section lists the system log messages that are generated by the PIM process.
Table 37. PIM system log messages
System log message Severity Description Recommended action
%PIM_ROUTE: IIF Mismatch For Informational There is a mismatch on the incoming
interface of a route learnt on the VLT
nodes. PIM_ROUTE: IIF Mismatch
For SRC: %s GRP: %s,Local IIF
%s & Peer IIF %s for VRF: %s
Occurred
Check the PIM interface and
VRF level configuration on
both the nodes.
%PIM_INTERFACE: PIM Informational PIM is configured on a default VLAN,
hence it is operationally disabled.
PIM_INTERFACE: PIM disabled
on interface :%s
No action required.
%PIM_PURGE_DELAY_START_
TIMER
Informational Synced multicast routes received from
the peer are retained for a duration of the
configured timer during a VLT peer node
failure. The following message indicates
that timer started for retaining the
routes. PIM detected multicast
peer-routing timer start
No action required.
%PIM_PURGE_DELAY_STOP_TI
MER
Informational Synced multicast routes received from
the peer are retained for duration of the
configured timer during a VLT peer node
failure. The following message indicates
that timer stopped and all stale multicast
entries are removed. PIM detected
multicast peer-routing timer
stop
No action required.
%PIM_PURGE_DELAY_START_
TIMER
Informational Synced multicast routes received from
peer are retained for duration of the
configured timer during a VLT peer
node failure. The following message
indicates that the timer has started for
retaining the routes: PIM detected
multicast peer-routing timer
start
No action required.
%PIM_PURGE_DELAY_STOP_TI
MER
Informational Synced multicast routes received from
peer are retained for duration of the
configured timer during a VLT peer node
failure. The following message indicates
that the timer has stopped and all
stale multicast entries are removed:
PIM detected multicast peer-
routing timer stop
No action required.
38
62 PIM system log message reference