Users Guide

OSPFv2 system log message reference
This section lists the system log messages that are generated by the OSPFv2 process.
Table 35. OSPFv2 system log messages
System log message Severity Description Recommended action
%OSPFV2_ADJ_CHANGE: OSPF
Process
Informational The OSPFv2 session state changes
from one state to other state. OSPF
Process VRF %s %d, Nbr %s
on %s state changed to %s
No action required.
%OSPFV2_BAD_VERSION:
OSPF detected bad version
Informational The received OSPF packet contains
wrong version information in OSPF
header. OSPF detected bad
version VRF %s from %s on
interface %s
Check the version of OSPF
process in peer and rectify
the same.
%OSPFV2_AREA_MISMATCH:
OSPF detected area-id mismatch
Informational The received OSPF packet's
source IP address not on same
network as receiving interface
the area mismatch error is
detected. OSPF detected area-
id mismatchVRF %s from %s
on interface %s
Check the configured area
details in neighbor device
or configured IP address
of neighbor interface and
correct it.
%OSPFV2_AUTH_TYPE_MISMA
TCH: OSPF detected mismatch in
authentication type
Informational The received OSPF packet's
authentication method type is
not matching with locally
configured authentication method.
OSPF detected mismatch in
authentication type VRF %s
from %s on interface %s
Check the configured
authentication methods
under OSPF interface and
correct the configuration.
%OSPFV2_AUTH_FAILURE:
OSPF detected authentication
failure
Informational The received OSPF packet can not
be authenticated. OSPF detected
authentication failure VRF
%s from %s on interface %s
Check the configured
authentication key in OSPF
interfaces and the configured
key value should match.
%OSPFV2_NETMASK_MISMATC
H: OSPF detected netmask
mismatch
Informational The received OSPF hello packet's
network mask field does not
match with interface's network
mask. OSPF detected netmask
mismatch VRF %s from %s on
interface %s
Check the configured
network mask on neighbor
interfae and configure the
correct netmask.
%OSPFV2_HELLO_INTERVAL:
OSPF detected hello interval
mismatch
Informational The received OSPF hello packet's
hello interval value does not match
with locally configured hello interval
value. OSPF detected hello
interval mismatch VRF %s
from %s on interface %s
Check and configure the
same hello interval value in
OSPF interfaces.
%OSPFV2_DEAD_INTERVAL:
OSPF detected dead interval
mismatch
Informational The received OSPF hello packet's
dead interval value does not match
with locally configured dead interval
value. OSPF detected dead
interval mismatch VRF %s
from %s on interface %s
Check and configure the
same dead interval value in
OSPF interfaces.
36
58 OSPFv2 system log message reference