Users Guide

FC_SVCS system log message reference
This section lists the system log messages that are generated by the FC_SVCS process.
Table 18. FC_SVCS system log messages
System log message Severity Description Recommended action
%FC_SVCS_MS_START_FABRI
C_RECONFIG: The Switch Starts
Informational This log is displayed in Multi-switch
mode, where any link failure in the
fabric that may result in Build Fabric
operation causing the Principal switch
re-election.
● Check if any node has
left the fabric due to link
failure.
● Check if any configured
fabric joins with another
fabric.
● Check is there any domain
ID overlap when joining
configured fabric with
another configured fabric
in case of RCF.
%FC_SVCS_MS_START_PRNC
PL_ELECTION: The Switch
Starts Principal Switch Election
Informational This log is displayed whenever the
Principal switch election happens in
the switch.
No action required.
%FC_SVCS_MS_PRNCPL_ELEC
TION_CMPLTD: Principal Switch
Election Completed.
Informational This log is displayed after Principal
switch election is completed.
No action required.
%FC_SVCS_MS_DOMAINID_AS
SIGN: DomainID
Informational This log is no longer valid. This log is no longer valid.
%FC_SVCS_MS_NOT_CAPABLE
_PRNCPL_SWITCH: No Switch
Capable to Become Principal
Switch.
Informational This log is displayed when the
principal-priority on a switch is set to
255.
If user wants want
this switch to become
principal switch, then
change the principal-priority
value accordingly in vfabric
configuration.
%FC_SVCS_MS_STABLE: The
Switch reaches the Stable State
Informational This log is displayed after Principal
switch election is completed and the
switch reaches stable state.
Information to the user.
%FC_SVCS_MS_EPORT_ISOLA
TED: Isolated
Informational This log is displayed when there
is mismatch in timer configuration
between two nodes.
Verify E_D_TOV and
R_A_TOV timer configuration
on the affected switches.
%FC_SVCS_NPG_SLB_IN_PRO
GRESS: Re-balance
Informational This log is displayed when the user
executes the re-balance npg sessions
second time where the re-balance
is already in progress, i.e user has
executed the command again before
it completes its operation of 1st
executed command.
Wait for the re-balance to
compelete successfully.
%FC_SVCS_NPG_SLB_SUCCES
S: Re-balance
Informational This log is displayed after the session
re-balance is successful.
No action required.
%FC_SVCS_NPG_SLB_SUCCES
S_STATE_CHANGE: Re-balance
Informational when a user executes the re-balance
npg session, it computes the session
distribution. Based on the computation
it starts tearing down the session,
also 30 second timer starts. The
User has to execute the re-
balance npg sessions again to
get the system into balanced
state.
19
38 FC_SVCS system log message reference