Users Guide

Table 8. BGP system log messages (continued)
System log message Severity Description Recommended action
8. "Router-id changed Nbr
over:%s VRF:%s recycled" 9.
"Invalid martian next hop
for Nbr over:%s VRF:%s" 10.
"Attribute len error for
Nbr over:%s VRF:%s" 11."BFD
Nbr over:%s VRF:%s DOWN"
12. "ADDPATH Denied Nbr
over:%s VRF:%s" NOTE: VRF
%s denotes VRF <vrf_name>
Nbr:%s denotes Nbr <IP or
unnumbered peer interface
name>
%BGP_MAX_PRFX_REACHED:
Maximum prefix limit per peer
exceeded.
Critical The number of prefixes sent to
this BGP neighbor or peer reached
the threshold value (a percentage
of the maximum number of prefixes
allowed). "Max Prefix hit from
nbr:%s in VRF:%s" NOTE: VRF
%s denotes VRF <vrf_name>
Nbr:%s denotes Nbr <IP or
unnumbered peer interface
name>
Use the
neighbor maximum-
prefix command to
change the threshold
value for that BGP
neighbor or peer.
%BGP_MAX_PRFX_THRESHOL
D: Maximum prefix threshold limit
per peer reached.
Warning The number of route prefixes sent to
a BGP neighbor exceeds the number
allowed in its configuration. "Max
Prefix Threshold hit from
nbr:%s in VRF:%s" NOTE: VRF
%s denotes VRF <vrf_name>
Nbr:%s denotes Nbr <IP or
unnumbered peer interface
name>
Determine if the neighbor
is configured properly. Use
the neighbor maximum-
prefix command to
increase the number of
prefixes allowed for that BGP
neighbor or peer.
%BGP_RM_OPER_STATE_CHA
NGE: RM operational state is
changed.
Informational BGP process operational status
is changed. "Received RM
State Change trap RM(vrf)
%s Oper_status:%d" NOTE:
VRF %s denotes VRF
<vrf_name> Oper_status:%d
denotes Oper_status 1(UP)
or 2(DOWN) or 3(GOING
UP) or 4(GOING DOWN) or
5(FAILED).
No Action required.
%BGP_NOTIFY_CONFIG_ERRO
R: Config Error
Warning BGP configuration failed due to
mentioned reason. Config Error
%S 1. PGR <pgr-name> with
add-path configured when
peer list has unnumbered
neighbor.2. suppress-map
will override summary-only
option 3. "Attempt to
configure Passive peergroup
when peer list has
unnumbered neighbor." 4.
"PGR and PEER Area
Mismatch.Config NotAllowed"
5. "Password configuration
failed" 6. "Unnum PGR
remote as configured when
Refer to the configuration
guidelines. If the issue
persists, contact Technical
Support.
24 BGP system log message reference