Users Guide

NOTE: If you have configured the policy using the match ra command, but not configured the
access lists or ACLs, the system bypasses the verification process. Generic ACL behavior applies
when the policy is attached to interface.
The no form of this command removes the configuration.
Example
OS10(conf-ra_guard_policy_list)# match ra ipv6-access-list
test_access_list
Supported
Releases
10.5.2.0 or later
other-config-flag
Verifies other advertised configuration parameter.
Syntax
other-config-flag {on | off}
Parameters
● on—Enables verification of the other advertised configuration parameter.
● off—Disables verification of the other advertised configuration parameter.
Default None
Command Mode RA GUARD POLICY LIST CONFIGURATION
Usage
Information
If you do not configure this command, the system bypasses the verification of the other configuration
parameter. The no form of this command removes the configuration.
Example
OS10(conf-ra_guard_policy_list)# other-config-flag on
Supported
Releases
10.5.2.0 or later
reachable-time
Verifies the configured reachability time in the received RA packets.
Syntax
reachable-time value
Parameters value—Enter the advertised reachability time in milliseconds, from 0 to 3600000.
Default None
Command Mode RA GUARD POLICY LIST CONFIGURATION
Usage
Information
The no form of this command resets the advertised reachability time.
Example
OS10(conf-ra_guard_policy_list)# reachable-time 100
Supported
Releases
10.5.2.0 or later
retrans-timer
Verifies the configured retransmission timer value in the received RA packets.
Syntax
retrans-timer value
Parameters value—Enter the advertised retransmission time interval in milliseconds, from 100 to 4294967295.
Default None
908 Layer 3