Users Guide

Usage
Information
The no version of this command deletes the FC zone. To delete an FC zone, first remove it from the FC
zoneset.
Example
OS10(config)# fc zone hba1
OS10(config-fc-zone-hba1)# member wwn 10:00:00:90:fa:b8:22:19
OS10(config-fc-zone-hba1)# member wwn 21:00:00:24:ff:7b:f5:c8
Supported
Releases
10.3.1E or later
fc zoneset
Creates an FC zoneset and adds the existing FC zones to the zoneset.
Syntax
fc zoneset zoneset-name
Parameters zoneset-name — Enter a name for the FC zoneset. The name must start with a letter and may contain
these characters: A-Z, a-z, 0-9, $, _, -, ^
Defaults Not configured
Command Mode CONFIGURATION
Usage
Information
The no version of this command removes the FC zoneset.
Example
OS10(config)# fc zoneset set
OS10(conf-fc-zoneset-set)# member hba1
Supported
Releases
10.3.1E or later
feature fc
Enables the F_Port globally.
Syntax
feature fc domain-id domain-id
Parameters domain-id — Enter the domain ID of the F_Port, from 1 to 239.
Defaults Disabled
Command Mode CONFIGURATION
Usage
Information
The no version of this command disables the F_Port. You can disable the F_Port only when vfabric
and zoning configurations are not available. Before disabling the F_Port, remove the vfabric and zoning
configurations. You can enable only one of the following at a time: F_Port, NPG, or FSB.
Example
OS10(config)# feature fc domain-id 100
Supported
Releases
10.3.1E or later
member (alias)
Add members to existing FC aliases. Identify a member by an FC alias, a world wide name (WWN), or an FC ID.
Syntax
member {wwn wwn-ID | fc-id fc-id}
Parameters
● wwn-ID — Enter the WWN name.
● fc-id — Enter the FC ID name.
480 Fibre Channel