Users Guide

Parameters string — Enter a text string for the interface description. A maximum of 240 characters.
Default Not configured
Command Mode INTERFACE
Usage
Information
● To use special characters as a part of the description string, enclose the string in double quotes.
● To use comma as a part of the description string add double back slash before the comma.
● Spaces between characters are not preserved after entering this command unless you enclose the
entire description in quotation marks; for example, “text description”.
● Enter a text string after the description command to overwrite any previously configured text
string.
● Use the show running-configuration interface command to view descriptions configured
for each interface.
● The no version of this command deletes the description.
Example
OS10(conf-if-eth1/1/7)# description eth1/1/7
Supported
Releases
10.2.0E or later
duplex
Configures Duplex mode on the Management port.
Syntax
duplex {full | half | auto}
Parameters
● full — Set the physical interface to transmit in both directions.
● half — Set the physical interface to transmit in only one direction.
● auto — Set the port to auto-negotiate speed with a connected device.
Defaults Not configured
Command Mode CONFIGURATION
Usage
Information
You can only use this command on the Management port. The no version of this command removes the
duplex mode configuration from the management port.
Example
OS10(conf-if-ma-1/1/1)# duplex auto
Supported
Releases
10.3.0E or later
enable dom
Enables or disables the DOM feature.
Syntax
dom enable
Parameters None
Default Disabled
Command Mode CONFIGURATION
Usage
Information
The no version of this command disables digital optical monitoring.
384 Interfaces