Users Guide

Table 6. New in 10.5.2.2 (continued)
Revision Date Feature Description
TLVs sent out through the
connected ports.
Multirack Layer 3 VLAN
network
An SFS template that is used
to configure IPv4 attributes
for the racks in an NXS-
T deployment consisting of
multirack leaf spine topology.
Table 7. New in 10.5.2.1
Revision Date Feature Description
A01 2020-11-23 Synchronous Ethernet
(SyncE) and hybrid clocking
SyncE is a physical
layer technology that
uses Synchronization Status
Message (SSM) and
Ethernet Synchronization
Message Channel (ESMC) to
achieve clock synchronization
between upstream and
downstream devices. When
the hybrid clocking mode
is enabled, SyncE is
used to provide frequency
synchronization, while PTP
is used to provide Time
of Day (ToD) and phase
synchronization.
Control-plane management
ACL logging
Monitors the control-plane
ACL flows and creates log
messages about packets that
match an access control
list entry (ACE) applied on
a management interface in
inbound direction.
Redistribute iBGP route to
OSPF
New CLI to allow or disallow
redistribution of the internal
BGP (iBGP) routes to OSPF.
View BGP routes based on
community attributes
New show commands to
display the BGP routes that
match a specific community
number, any community
number from the community
list, or any extended attribute
from the extended community
list.
CLI enhancements
● The show tech-
support command
now displays transceiver
information.
● The transceiver and
interface parameters
are now optional for the
show interface phy-
eth command.
● Based on the BGP
as-notation present
Change history 33