Users Guide

Inform :0
Decline :0
PACKETS SENT
----------------------
Bootrequest :5
Booteply :4
Offer :2
Ack :2
Nack :0
PACKETS DROPPED
----------------------
Invalid opcode :0
Invalid option :0
Total Dropped :1
Supported
Release
10.5.2.3 or later
show vlt mismatch dhcp-relay
Displays the mismatch (if any), between the VLT peer for the DHCP relay options configuration on the Global level, VRF levels,
and VLANs spanned across the VLT peers.
Syntax
show vlt vlt-domain mismatch dhcp-relay
Parameters None.
Defaults None
Command Mode EXEC
Usage
Information
This command shows the mismatch in the global ip dhcp-relay vss and ip dhcp-relay
server-override commands.
This command shows the codes for the mismatch between the VLT peers for the server-override
configuration and vss-info values for the spanned VLANs or virtual-networks. This command also
displays the presence or absence of VRF or interface level source-interface configurations whenever the
interface IP address on the client-facing interface is not present.
This command is restricted to netadmin and sysadmin role users.
Example
(Interface)
OS10(conf-if-po-20)# do show vlt 100 mismatch dhcp-relay
Global relay Configuration Mismatch
------------------------------------------------------------------
VLT Unit ID Link-Selection Server-Override VSS
------------------------------------------------------------------
* 1 enabled - disabled
2 disabled - enabled
VRF relay Configuration Mismatch
-------------------------------------------------------------------
VRF : VRF_RED
VLT Unit ID Source-Interface
-----------------------------------
* 1 Present
2 Not Present
Interface Relay Configuration Mismatch
---------------------------------------------------------------------
VLAN: 10
VLT Unit ID Server-Override VSS Source-Interface
---------------------------------------------------------------------
* 1 enabled type-0(Red) -
2 disabled type-0(Blue) -
VNI: 20
VLT Unit ID Server-Override VSS Source-Interface
312 System management