Manualshelf

Users Guide

ManualsBrandsDell ManualsAccess PlatformsSmartFabric OS10 Documentation
241242243244245246247248249250
Table Of Contents
● g781—Enables G.781-related debug logs.
Default None
Command Mode EXEC
Security and
Access
Netadmin and sysadmin
Usage
Information
The debug log messages are logged in the /var/log/synce.log file.
Example
OS10# debug sync-e esmc
Supported
Releases
10.5.2.1 or later
show debug sync-e
Shows the debug options enabled for Sync-E.
Syntax
show debug sync-e
Parameters None
Default None
Command Mode EXEC
Usage
Information
None
Example
OS10# show debug sync-e
sync-e debug settings:
debug sync-e all
Supported
Releases
10.5.2.1 or later
show sync-e
Displays the SyncE information and synchronization status.
Syntax
show sync-e
Parameters None
Default None
Command Mode EXEC
Usage
Information
Use this command to view the SyncE information such as lock status, selection process state, selected
references (primary and secondary), selected QL, and information about each clock sources. The
following selection process states are displayed in the output:
● Selection Process State
○ State 1A: QL-enabled mode, no active switch request.
○ State 1B: QL-enabled mode, active manual switch request.
○ State 1C: QL-enabled mode, active forced switch.
○ State 2A: QL-disabled mode, no active switch request.
○ State 2B: QL-disabled mode, active manual switch request.
○ State 2C: QL-disabled mode, active forced switch request.
To know more about the working states of the clock sources, see Clock source states.
242 System management