Users Guide

Usage
Information
This command clears the lockout state on a specific interface or all the interfaces. After clearing the
lockout status, the SyncE clock source on the interface is considered available for the selection process.
Example
OS10# clear sync-e lockout ethernet 1/1/1
Supported
Releases
10.5.2.1 or later
clear sync-e switch
Clears the manual or forced selection of a clock source.
Syntax
clear sync-e switch
Parameters None
Default None
Command Mode EXEC
Security and
Access
Netadmin and sysadmin
Usage
Information
This command clears the active manual or force switched clock reference. Clearing the force-switch
reinitiates the clock selection process.
Example
OS10# clear sync-e switch
Supported
Releases
10.5.2.1 or later
clear sync-e wait-restore-time
Clears the wait-to-restore state of a specific interface or all interfaces.
Syntax
clear sync-e wait-restore-time [ethernet node/slot/port]
Parameters ethernet node/slot/port—(Optional) Enter a physical Ethernet interface.
Default None
Command Mode EXEC
Security and
Access
Netadmin and sysadmin
Usage
Information
Use this command to reset the timer for a specific interface or all the interfaces that are in the wait-
to-restore state. Clearing this timer makes the clock sources to be available for the selection process
immediately.
Example
OS10# clear sync-e wait-restore-time ethernet 1/1/1
Supported
Releases
10.5.2.1 or later
debug sync-e
Enables debug logs for G.781 and ESMC (G.8264).
Syntax
[no] debug sync-e {all | esmc | g781}
Parameters
● all—Enables all debug logs of the system.
● esmc—Enables ESMC-related debug logs.
System management 241