Manualshelf

Users Guide

ManualsBrandsDell ManualsAccess PlatformsSmartFabric OS10 Documentation
1821182218231824182518261827182818291830
Table Of Contents
Although the default management route was configured during installation, you can use the route add default gw
command from the Linux shell to configure the default management IP address for routing. SupportAssist requires the default
management route is configured to work properly, as well as DNS configured and a route to a proxy server.
How do I log into the OS10 shell as the system administration?
Use linuxadmin as the username and password to enter OS10 at root level.
Where can I find additional installation information for my specific device?
See the Setup Guide shipped with your device or the platform-specific Installation Guide on the Dell EMC Support page at
dell.com/support.
Hardware
What are the default console settings for ON-Series devices?
● Set the data rate to 115200 baud
● Set the data format to 8 bits, stop bits to 1, and no parity
● Set flow control to none
How do I view the hardware inventory?
Use the show inventory command to view complete system inventory.
How do I view the process-related information?
Use the show processes node-id node-id-number [pid process-id] command to view the process CPU
utilization information.
Configuration
How do I enter CONFIGURATION mode?
Use the configure terminal command to change from EXEC mode to CONFIGURATION mode.
I made changes to the running configuration file but the updates are not showing. How do I view my changes?
Use the show running-configuration command to view changes that you have made to the running-configuration file.
Here are the differences between the available configuration files:
● startup-configuration contains the configuration applied at device startup
● running-configuration contains the current configuration of the device
● candidate-configuration is an intermediate temporary buffer that stores configuration changes prior to applying them to the
running-configuration
Security
How do I add new users?
Use the username commands to add new users. Use the show users command to view a list of current users.
How do I view RADIUS transactions to troubleshoot problems?
Use the debug radius command.
How do I view the current DHCP binding information?
Use the show ip dhcp binding command.
Layer 2
How do I view the VLAN running configuration?
Use the show vlan command to view all configured VLANs.
1828
Troubleshoot Dell EMC SmartFabric OS10