Users Guide

When you copy the custom profile, you must update the name of the custom profile. You cannot use the same name as the
default profile (default.xml) or the active profile (mySevProf.xml).
5. Apply the custom severity profile on the switch.
OS10# event severity-profile mySevProf_1.xml
NOTE: You must restart the switch for the changes to take effect.
6. Restart the switch.
OS10# reload
7. Use the show event severity-profile command to view the custom profile that is active.
OS10# show event severity-profile
Severity Profile Details
--------------------------------------------
Currently Active : default
Active after restart : mySevProf_1.xml
Delete custom severity profile
You can delete custom severity profiles that you no longer need. However, you cannot delete the default or active severity
profile.
To delete a custom severity profile, use the delete severity-profile://profile-name command. For example:
OS10# delete severity-profile://mySevProf_1.xml
System logging
You can change the system logging default settings using the severity level to control the type of system messages that log.
The range of logging severities are:
● log-emerg—System is unstable.
● log-alert—Immediate action is needed.
● log-crit—Critical conditions
● log-err—Error conditions
● log-warning—Warning conditions
● log-notice—Normal, but significant conditions (default)
● log-info—Informational messages
● log-debug—Debug messages
NOTE: The system rate-limits syslog messages to a maximum of 10 per second on the console.
● Enter the minimum severity level for logging to the console in CONFIGURATION mode.
logging console severity
● Enter the minimum severity level for logging to the system log file in CONFIGURATION mode.
logging log-file severity
● Enter the minimum severity level for logging to terminal lines in CONFIGURATION mode.
logging monitor severity
1806
Troubleshoot Dell EMC SmartFabric OS10