Reference Guide

• If a physical interface is a part of a dynamic LAG, the channel-group id command is rejected on that interface.
• You cannot add static and dynamic members to the same LAG.
• There is a dierence between the shutdown and no interface port-channel commands:
• The shutdown command on LAG xyz disables the LAG and retains the user commands.
• The no interface port-channel channel-number command deletes the specied LAG, including a dynamically created
LAG. The interfaces restore and are ready for conguration.
• A maximum of 128 port-channels with up to 16 members per channel are allowed.
Conguration
LACP is enabled globally by default. You can congure aggregated ports with compatible active and passive LACP modes to automatically
link them.
1 Congure the system priority in CONFIGURATION mode (1 to 65535; the higher the number, the lower the priority; default 32768).
lacp system-priority priority-value
2 Congure the LACP port priority in INTERFACE mode (1 to 65535; the higher the number, the lower the priority; default 32768).
lacp port-priority priority-value
3 Congure the LACP rate in INTERFACE mode (default normal).
lacp rate [fast | normal]
4 Save the conguration.
do commit
Congure LACP
OS10(config)# lacp system-priority 65535
OS10(config)# interface range ethernet 1/1/7-1/1/8
OS10(conf-range-eth1/1/7-1/1/8)# lacp port-priority 4096
OS10(conf-range-eth1/1/7-1/1/8)# lacp rate fast
OS10(conf-range-eth1/1/7-1/1/8)# do commit
Verify LACP conguration
OS10(conf-range-eth1/1/7-1/1/8)# do show running-configuration
...
!
interface ethernet1/1/7
lacp port-priority 4096
lacp rate fast
no shutdown
!
interface ethernet1/1/8
lacp port-priority 4096
lacp rate fast
no shutdown
!
...
Interfaces
Create a LAG and then add LAG member interfaces. By default, all interfaces are in no shutdown and switchport modes.
1 Create a LAG in CONFIGURATION mode.
interface port-channel port-channel number
2 Enter INTERFACE mode.
interface ethernet node/slot/port[:subport]
100
Layer 2