Users Guide

Command Mode EXEC
Usage
Information
In the State field, true indicates that the port is enabled. In the Reason field, Is UP indicates that hardware resources are allocated .
This command is introduced on the MX9116n and MX5108n with support for full-switch mode from the Dell EMC SmartFabric OS release 10.4.0(R3S).
Example
(specific
session)
OS10# show monitor session 1
S.Id Source Destination Dir Mode Source IP Dest IP DSCP TTL Gre-Protocol State Reason
------------------------------------------------------------------------------------------------------
1 ethernet1/1/1 remote-ip both port 11.11.11.1 11.11.11.11 0 255 35006 true Is UP
Example (all
sessions)
OS10# show monitor session all
S.Id Source Destination Dir Mode Source IP Dest IP DSCP TTL Gre-Protocol State Reason
------------------------------------------------------------------------------------------------------------
1 ethernet1/1/1 remote-ip both port 11.11.11.1 11.11.11.11 0 255 35006 true Is UP
9 ethernet1/1/9 both port N/A N/A N/A N/A N/A
7 ethernet1/1/9 vlan40 both port N/A N/A N/A N/A N/A
4 ethernet1/1/1 both port N/A N/A 0 255 35006 false
Destination is not resolved
6 ethernet1/1/2 remote-ip both port 11.11.11.1 2.2.2.1 0 255 35006 false Base
session does not exist
Supported
Releases
10.2.0E or later
shut
Disables the monitoring session. The monitoring session can be: local, RPM, or ERPM.
Syntax
shut
Parameters None
Default Disabled
Command Mode MONITOR-SESSION
Usage
Information
The no version of this command enables the monitoring session.
This command is introduced on the MX9116n and MX5108n with support for full-switch mode from the
Dell EMC SmartFabric OS release 10.4.0(R3S).
Example
OS10(config)# monitor session 1
OS10(conf-mon-local-1)# no shut
OS10(config)# monitor session 5 type rpm-source
OS10(conf-mon-rpm-source-5)# no shut
OS10(config)# monitor session 10 type erpm-source
OS10(conf-mon-erpm-source-10)# no shut
Supported
Releases
10.2.0E or later
source
Configures a source for port monitoring. The monitoring session can be: local, RPM, or ERPM.
Syntax
source interface interface-type {both | rx | tx}
Parameters
● interface-type—Enter the interface type:
○ ethernet node/slot/port[:subport]—Enter the Ethernet interface information as the
monitored source.
Layer 2 563