Reference Guide

By default, a trunk interface carries only untagged trac on the access VLAN — you must manually congure other VLANs for tagged
trac.
1 Select one of the two available options:
• Congure L2 trunking in INTERFACE mode and the tagged VLAN trac that the port can transmit. By default, a trunk port is not
added to any tagged VLAN. You must create a VLAN before you can assign the interface to it.
switchport mode trunk
switchport trunk allowed vlan vlan-id-list
• Recongure the access VLAN assigned to a L2 access or trunk port in INTERFACE mode.
switchport access vlan vlan-id
2 Enable the interface for L2 trac transmission in INTERFACE mode.
no shutdown
L2 interface conguration
OS10(config)# interface ethernet 1/1/7
OS10(conf-if-eth1/1/7)# switchport mode trunk
OS10(conf-if-eth1/1/7)# switchport trunk allowed vlan 5,10
OS10(conf-if-eth1/1/7)# no shutdown
L3 mode conguration
Ethernet and port-channel interfaces are in L2 access mode by default. When you disbale L2 mode and then assign an IP address to an
Ethernet port interface, you place the port in L3 mode.
Congure one primary IP address in L3 mode. You can congure up to 255 secondary IP addresses on an interface. At least one interface in
the system must be in L3 mode before you congure or enter a L3 protocol mode, such as OSPF.
1 Remove a port from L2 switching in INTERFACE mode.
no switchport
2 Congure L3 routing in INTERFACE mode. Add the keyword secondary to congure backup IP addresses.
ip address address [secondary]
3 Enable the interface for L3 trac transmission in INTERFACE mode.
no shutdown
L3 interface conguration
OS10(config)# interface ethernet 1/1/9
OS10(conf-if-eth1/1/9)# no switchport
OS10(conf-if-eth1/1/9)# ip address 10.10.1.92/24
OS10(conf-if-eth1/1/9)# no shutdown
View L3 conguration error
OS10(config)# interface ethernet 1/1/1
OS10(conf-if-eth1/1/1)# ip address 1.1.1.1/24
% Error: remove Layer 2 configuration before assigning an IP
Fibre Channel interfaces
OS10 unied port groups support Fibre Channel (FC) interfaces. A unied port group operates in Fibre Channel or Ethernet mode. To
activate FC interfaces, congure a port group to operate in Fibre Channel mode and specify the port speed. By default, FC interfaces are
disabled. To enable a FC interface for data transmission, enter no shutdown.
68
Interfaces