Reference Guide

dot1x timeout supp-timeout
Sets the number of seconds that the device waits for the supplicant to respond to an EAP request frame before the device retransmits the
frame.
Syntax
dot1x timeout supp-timeout seconds
Parameters supp-timeout seconds — Enter the number of seconds for the 802.1X supplicant timeout (1 to 65535).
Default 30 seconds
Command Mode INTERFACE
Usage Information The no version of this command resets the value to the default.
Example
OS10(conf-range-eth1/1/7-1/1/8)# dot1x timeout supp-timeout 45
Supported Releases 10.2.0E or later
dot1x timeout tx-period
Sets the number of seconds that the device waits for a response to an EAP-request/identity frame from the supplicant before
retransmitting the request.
Syntax
dot1x timeout tx-period seconds
Parameters tx-period seconds — Enter the number of seconds for the 802.1X transmission timeout (1 to 65535).
Default 60 seconds
Command Mode INTERFACE
Usage Information The no version of this command resets the value to the default.
Example
OS10(conf-range-eth1/1/7-1/1/8)# dot1x timeout tx-period 120
Supported Releases 10.2.0E or later
show dot1x
Displays global 802.1X conguration information.
Syntax
show dot1x
Parameters None
Default Not congured
Command Mode EXEC
Usage Information None
Example
OS10# show dot1x
PAE Capability: Authenticator only
Protocol Version: 2
System Auth Control: Enable
Auth Server: Radius
Supported Releases 10.2.0E or later
128 Layer 2