Deployment Guide

Usage
information
The untagged VLAN ID is used internally for all untagged member interfaces that belong to virtual
networks. You cannot use the reserved untagged VLAN ID for a simple VLAN bridge or for tagged traffic
on member interfaces of virtual networks. The no version of this command removes the configured value.
Example
OS10(config)# virtual-network untagged-vlan 10
Supported
releases
10.4.2.0 or later
vxlan-vni
Assigns a VXLAN ID to a virtual network.
Syntax
vxlan-vni vni
Parameters
vni
Enter the VXLAN ID for a virtual network, from 1 to 16,777,215.
Default Not configured
Command mode VIRTUAL-NETWORK
Usage
information
This command associates a VXLAN ID number with a virtual network. The no version of this command
removes the configured ID.
Example
OS10(conf-vn-100)# vxlan-vni 100
OS10(config-vn-vxlan-vni)#
Supported
releases
10.4.2.0 or later
VXLAN MAC commands
clear mac address-table dynamic nve remote-vtep
Clears all MAC addresses learned from a remote VTEP.
Syntax
clear mac address-table dynamic nve remote-vtep ip-address
Parameters
remote-vtep
ip-address
Clear MAC addresses learned from the specified remote VTEP.
Default Not configured
Command mode EXEC
Usage
information
To display the MAC addresses learned from a remote VTEP, use the show mac address-table nve
remote-vtep command. Use this command to delete all MAC address entries learned from a remote
VTEP.
Example
OS10# clear mac address-table dynamic nve remote-vtep 32.1.1.1
Supported
releases
10.4.2.0 or later
32 VXLAN