Connectivity Guide

Supported
Releases
10.3.0E or later
trust dscp-map
Creates a user-defined trust map for DSCP flows.
Syntax
trust dscp-map map-name
Parameters map-name — Enter the name of the DSCP trust map. A maximum of 32 characters.
Default Not configured
Command Mode CONFIGURATION
Usage
Information
If you enable trust, traffic obeys this trust map. default-dscp-trust is a reserved trust-map name.
The no version of this command returns the value to the default.
Example
OS10(config)# trust dscp-map dscp-trust1
Supported
Releases
10.3.0E or later
qos-map traffic-class
Creates a user-defined trust map for queue mapping. In S5148F-ON, apply the traffic class only on the egress traffic.
Syntax
qos-map traffic-class map-name
Parameters map-name — Enter the name of the queue trust map. A maximum of 32 characters.
Default Not configured
Command Mode CONFIGURATION
Usage
Information
If applied on the interface or system level, the traffic class routes all traffic to the mapped queue. The no
version of this command returns the value to the default.
Example
OS10(config)# qos-map traffic-class queue-map1
OS10(config-qos-map)# queue 1 qos-group 5
OS10(config-qos-map)# queue 2 qos-group 6
OS10(config-qos-map)# queue 3 qos-group 7
OS10(config-qos-map)#
Supported
Releases
10.3.0E or later
trust-map
Applies a dot1p or DSCP traffic class to a queue trust map.
Syntax
trust {dot1p | dscp} {default | trust-map-name}
Parameters
● dot1p— Applies a dot1p trust map.
● dscp—Applies a dscp trust map.
● default— Applies a default trust map.
Default Disabled
Command Mode
SYSTEM-QOS
INTERFACE
984 Quality of service