Connectivity Guide

network-qos type policy-maps. When you configure interface-level policies and system-level policies,
the interface-level policy takes precedence over the system-level policy.
Example
OS10(conf-if-eth1/1/7)# service-policy input type qos p1
Supported
Releases
10.2.0E or later
set cos
Sets a cost of service (CoS) value to mark L2 802.1p (dot1p) packets.
Syntax
set cos cos-value
Parameters cos-value — Enter a CoS value, from 0 to 7.
Default Not configured
Command Mode POLICY-MAP-CLASS-MAP
Usage
Information
You cannot enter two set statements with the same action-type. If you enter two set statements with
the same action-type, the second statement overwrites the first. When class-map type is qos, the
qos-group corresponds to data queues 0 to 7.
Example
OS10(conf-pmap-c-qos)# set cos 6
Supported
Releases
10.2.0E or later
set dscp
Sets the drop precedence for incoming packets based on their DSCP value and color map profile.
Syntax
set dscp dscp-value
Parameters dscp-value — Enter a DSCP value, from 0 to 63.
Default Not configured
Command Mode POLICY-MAP-CLASS-MAP
Usage
Information
When class-map type is qos, the qos-group corresponds to data queues 0 to 7.
Example
OS10(conf-pmap-c-qos)# set dscp 10
Supported
Releases
10.2.0E or later
set qos-group
Configures marking for the QoS-group queues.
Syntax
set qos-group queue-number
Parameters queue-number — Enter a queue number, from 0 to 7.
Default Not configured
Command Mode POLICY-MAP-CLASS-MAP
966 Quality of service