Manualshelf

Connectivity Guide

ManualsBrandsDell ManualsAccess PlatformsSmartFabric OS10 Documentation
951952953954955956957958959960
Table Of Contents
Usage
Information
You cannot enter two match statements with the same filter-type. If you enter two match statements
with the same filter-type, the second statement overwrites the first statement.
Example
OS10(conf-cmap-qos)# match vlan 100
Supported
Releases
10.2.0E or later
mtu
Calculates the buffer size allocation for matched flows.
Syntax
mtu size
Parameters size — Enter the size of the buffer (1500 to 9216).
Default 9216
Command Mode POLICY-MAP-CLASS-MAP
Usage
Information
The no version of this command returns the value to the default.
Example
OS10(conf-pmap-nqos-c)# mtu 2500
Supported
Releases
10.3.0E or later
pause
Enables a pause based on buffer limits for the port to start or stop communication to the peer.
Syntax
pause [buffer-size size pause-threshold xoff-size resume-threshold xon-
size]
Parameters
● buffer-size size — (Optional) Enter the ingress buffer size used as a guaranteed buffer in KB, .
○ Default values for PFC: 10G, 25G–183KB, 40G–375KB, 100G–446KB
○ Default values for LLFC: 10G,25G–207.5KB, 40G,100G–300.5KB
● pause-threshold xoff-size — (Optional) Enter the buffer limit for the port to start or initiate
a pause to the peer in KB, .
○ Default values for PFC: 10G, 25G–96KB, 40G–192KB, 100G–232KB
○ Default values for LLFC: 10G,25G–198.5KB, 40G,100G–264.5KB
● resume-threshold xon-size — (Optional) Enter the buffer limit for the port to stop or cancel
sending a pause to the peer in KB .
○ Default values for PFC: 10G, 25G–87KB, 40G–183KB, 100G–214KB
○
Default values for LLFC: 10G,25G–9KB, 40G,100G–36KB
Default See parameter values
Command Mode POLICY-MAP-CLASS-MAP
Usage
Information
Only use this command under the network-qos policy type. Buffer-size, pause-thresholds, and resume-
thresholds vary based on platform. Add the policy-map with pause to system-qos to service an input
to enable pause on all ports, based on a per-port link-level Flow-Control mode. The xoff and xon
threshold settings for link-level flow-control are applied on ports where all traffic classes must be mapped
to a single PG. Platform-specific default values are based on MTU sizes of 9216 and cable length of 100
meters. The no version of this command returns the value to the default.
Example
OS10(conf-pmap-c-nqos)# pause buffer-size 45 pause-threshold 25 resume-
threshold 10
956 Quality of service