Connectivity Guide

sets the MED of the advertised routes to the IGP cost of the next hop of the advertised route. If the
cost of the next hop changes, BGP is not forced to readvertise the route.
○ external — Reverts to the normal BGP rules for propagating the MED, the default.
○ internal — Sets the MED of a received route that is being propagated to an external peer equal
to the IGP costs of the indirect next hop.
● OSPF
○ external — Sets the cost of the external routes so that it is equal to the sum of all internal
costs and the external cost.
○ internal — Sets the cost of the external routes so that it is equal to the external cost alone,
the default.
The no version of this command removes the set clause from a route map.
Example
OS10(conf-route-map)# set metric-type internal
Supported
Releases
10.2.0E or later
set next-hop
Sets an IPv4 or IPv6 address as the next-hop.
Syntax
set {ip | ipv6} next-hop ip-address
Parameters ip-address — Enter the IPv4 or IPv6 address for the next-hop.
Default Not configured
Command Mode ROUTE-MAP
Usage
Information
If you apply a route-map with the set next-hop command in ROUTER-BGP mode, it takes precedence
over the next-hop-self command used in ROUTER-NEIGHBOR mode. In a route-map configuration,
to configure more than one next-hop entry, use multiple set {ip | ipv6} next-hop commands.
When you apply a route-map for redistribution or route updates in ROUTER-BGP mode, configure only
one next-hop. Configure multiple next-hop entries only in a route-map used for other features. The no
version of this command deletes the setting.
Example
OS10(conf-route-map)# set ip next-hop 10.10.10.2
Example (IPv6)
OS10(conf-route-map)# set ipv6 next-hop 11AA:22CC::9
Supported
Releases
10.2.0E or later
set origin
Set the origin of the advertised route.
Syntax
set origin {egp | igp | incomplete}
Parameters
● egp — Enter to add to existing community.
● igp — Enter to send inside the local-AS.
● incomplete — Enter to not advertise to peers.
Default Not configured
Command Mode ROUTE-MAP
Usage
Information
The no version of this command deletes the set clause from a route map.
Access Control Lists 911