Connectivity Guide

Usage
Information
OS10 cannot count both packets and bytes; when you use the count byte options, only bytes
increment. The no version of this command removes the filter.
The count, byte, and log options are not supported on the S5148F-ON platform.
Example
OS10(config)# ipv6 access-list ipv6test
OS10(conf-ipv6-acl)# deny udp any any capture session 1
Supported
Releases
10.2.0E or later
description
Configures an ACL description.
Syntax
description text
Parameters text — Enter the description text string. A maximum of 80 characters.
Default Disabled
Command Modes IPV4-ACL, IPV6-ACL, MAC-ACL
Usage
Information
The no version of this command deletes the ACL description.
Example
OS10(conf-ipv4-acl)# description ipacltest
Supported
Releases
10.2.0E or later
ip access-group
Configures an IPv4 access group.
Syntax
ip access-group access-list-name {in | out}
Parameters
● access-list-name — Enter the name of an IPv4 access list. A maximum of 140 characters.
● in — Apply the ACL to incoming traffic.
● out — Apply the ACL to outgoing traffic.
Default Not configured
Command Mode
INTERFACE
CONTROL-PLANE
Usage
Information
Use this command in the CONTROL-PLANE mode to apply a control-plane ACL. Control-plane ACLs are
only applied on the ingress traffic. By default, the control-plane ACL is applied to the front-panel ports as
well as the management port.The no version of this command deletes the IPv4 ACL configuration.
Example
OS10(conf-if-eth1/1/8)# ip access-group testgroup in
Example
(Control-plane
ACL)
OS10# configure terminal
OS10(config)# control-plane
OS10(config-control-plane)# ip access-group aaa-cp-acl in
Supported
Releases
10.2.0E or later; 10.4.1 or later (control-plane ACL)
Access Control Lists 863