Connectivity Guide

● Enter the IP address in A.B.C.D format of the next-hop for a BGP route update in ROUTE-MAP mode.
set ip next-hop address
● Enter an IPv6 address in A::B format of the next-hop for a BGP route update in ROUTE-MAP mode.
set ipv6 next-hop address
● Enter the range value for the BGP route’s LOCAL_PREF attribute in ROUTE-MAP mode, from 0 to 4294967295.
set local-preference range-value
● Enter a metric value for redistributed routes in ROUTE-MAP mode, from 0 to 4294967295.
set metric {+ | - | metric-value}
● Enter an OSPF type for redistributed routes in ROUTE-MAP mode.
set metric-type {type-1 | type-2 | external | internal}
● Enter an ORIGIN attribute in ROUTE-MAP mode.
set origin {egp | igp | incomplete}
● Enter a tag value for the redistributed routes in ROUTE-MAP mode, from 0 to 4294967295.
set tag tag-value
● Enter a value as the route’s weight in ROUTE-MAP mode, from 0 to 65535.
set weight value
Check set conditions
OS10(config)# route-map ip permit 1
OS10(conf-route-map)# match metric 2567
Continue clause
Only BGP route-maps support the continue clause. When a match is found, set clauses run and the packet forwards — no
route-map processing occurs. If you configure the continue clause without configuring a module, the next sequential module
processes.
If you configure the continue command at the end of a module, the next module processes even after a match is found. The
example shows a continue clause at the end of a route-map module — if a match is found in the route-map test module 10,
module 30 processes.
Route-map continue clause
OS10(config)# route-map test permit 10
OS10(conf-route-map)# continue 30
ACL flow-based monitoring
Flow-based monitoring conserves bandwidth by selecting only the required flow to mirror instead of mirroring entire packets
from an interface. This feature is available for L2 and L3 ingress traffic. Specify flow-based monitoring using ACL rules.
Flow-based monitoring copies incoming packets that match the ACL rules applied on the ingress port and forwards, or mirrors
them to another port. The source port is the monitored port (MD), and the destination port is the monitoring port (MG).
When a packet arrives at a monitored port, the packet validates against the configured ACL rules. If the packet matches an
ACL rule, the system examines the corresponding flow processor and performs the action specified for that port. If the mirroring
action is set in the flow processor entry, the port details are sent to the destination port.
850
Access Control Lists