Connectivity Guide

Example
OS10# system bash
admin@OS10:~$ pwd
/config/home/admin
admin@OS10:~$ exit
OS10#
Supported
Releases
10.2.0E or later
system-cli disable
Disables system command.
Syntax
system-cli disable
Parameters None
Default Enabled
Command Mode CONFIGURATION
Usage
Information
The no version of this command enables OS10 system command.
Example
OS10# configure terminal
OS10(config)# system-cli disable
Supported
Releases
10.4.3.0 or later
system identifier
Sets a non-default unit ID in a non-stacking configuration.
Syntax
system identifier system-identifier-ID
Parameters system-identifier-ID — Enter the system identifier ID, from 1 to 9.
Default Not configured
Command Mode CONFIGURATION
Usage
Information
The system ID displays in the stack LED on the switch front panel.
Example
OS10(config)# system identifier 1
Supported
Releases
10.3.0E or later
terminal
Sets the number of lines to display on the terminal and enables logging.
Syntax
terminal {length lines | monitor}
Parameters
● length lines — Enter the number of lines to display on the terminal, from 0 to 512, default 24.
● monitor — Enables logging on the terminal.
Default 24 terminal lines
Command Mode EXEC
82 Getting Started