Connectivity Guide

exit
Returns to the next higher command mode.
Syntax
exit
Parameters None
Default Not configured
Command Mode All
Usage
Information
None
Example
OS10(conf-if-eth1/1/1)# exit
OS10(config)#
Supported
Releases
10.2.0E or later
hostname
Sets the system host name.
Syntax
hostname name
Parameters name — Enter the host name of the switch, up to 64 characters.
Default OS10
Command Mode CONFIGURATION
Usage
Information
The host name is used in the OS10 command-line prompt. The no version of this command resets the
host name to OS10.
Example
OS10(conf)# hostname R1
R1(conf)#
Supported
Releases
10.3.0E or later
license
Installs a license file from a local or remote location.
Syntax
license install [ftp: | http: | localfs: | scp: | sftp: | tftp: | usb:]
filepath
Parameters
● ftp: — (Optional) Install from the remote file system (ftp://userid:passwd@hostip/
filepath).
● http[s]: — (Optional) Install from the remote file system (http://hostip/filepath).
● http[s]: — (Optional) Request from remote server (http://hostip).
● localfs: — (Optional) Install from the local file system (localfs://filepath).
● scp: — (Optional) Request from the remote file system (scp://userid:passwd@hostip/
filepath).
● sftp: — (Optional) Request from the remote file system (sftp://userid:passwd@hostip/
filepath).
● tftp: — (Optional) Request from the remote file system (tftp://hostip/filepath).
● usb: — (Optional) Request from the USB file system (usb://filepath).
Default Not configured
66 Getting Started