Connectivity Guide

Eth 1/1/9 up 40G A 1 -
Eth 1/1/10 up 40G A 1 -
Eth 1/1/11 up 40G A 1 -
Eth 1/1/12 up 40G A 1 -
Eth 1/1/13 up 40G A 1 -
Eth 1/1/14 up 40G A 1 -
Eth 1/1/15 up 40G A 1 -
Eth 1/1/16 up 40G A 1 -
Eth 1/1/17 up 40G A 1 -
Eth 1/1/18 up 40G A 1 -
Eth 1/1/19 up 40G A 1 -
Eth 1/1/20 up 40G A 1 -
Eth 1/1/21 up 40G A 1 -
Eth 1/1/22 up 40G A 1 -
Eth 1/1/23 up 40G A 1 -
Eth 1/1/24 up 40G A 1 -
Eth 1/1/25 up 40G A 1 -
Eth 1/1/26 up 40G A 1 -
Eth 1/1/27 up 40G A 1 -
Eth 1/1/28 up 40G A 1 -
Eth 1/1/29 up 40G A 1 -
Eth 1/1/30 up 40G A 1 -
Eth 1/1/31 up 40G A 1 -
Eth 1/1/32 up 40G A 1 -
--------------------------------------------------------------------------------
In this example, when you enter goint 1/1/1, note that the text on the CLI changes to interface ethernet
1/1/1.
OS10(config)# alias goint "interface ethernet $1"
OS10(config)# goint 1/1/1
OS10(conf-if-eth1/1/1)#
Supported
Releases
10.3.0E or later
alias (multi-line)
Creates a mulit-line command alias.
Syntax
alias alias-name
Parameters alias-name — Enter the name of the multi-line alias. A maximum of up to 20 characters.
Default Not configured
Command Mode CONFIGURATION
Usage
Information
Use this command to save a series of multiple commands in an alias. The switch enters ALIAS mode when
you create an alias. You can enter the series of commands to be executed using the line command. The
no version of this command deletes an alias.
Example
OS10(config)# alias mTest
OS10(config-alias-mTest)# line 1 "interface $1 $2"
OS10(config-alias-mTest)# line 2 "no shutdown"
OS10(config-alias-mTest)# line 3 "show configuration"
Supported
Releases
10.4.0E(R1) or later
Getting Started 59