Connectivity Guide

Example
OS10(config)# interface ethernet 1/1/6
OS10(conf-if-eth1/1/6)# ipv6 ospf priority 4
Supported
Releases
10.3.0E or later
log-adjacency-changes
Enables logging of syslog messages about changes in the OSPFv3 adjacency state.
Syntax
log-adjacency-changes
Parameters None
Default Disabled
Command Mode ROUTER-OSPFv3
Usage
Information
The no version of this command resets the value to the default.
Example
OS10(config)# router ospfv3 100
OS10(config-router-ospfv3-100)# log-adjacency-changes
Supported
Releases
10.3.0E or later
maximum-paths
Enables forwarding of packets over multiple paths.
Syntax
maximum—paths number
Parameters number —Enter the number of paths for OSPFv3, from 1 to 128.
Default Disabled
Command Mode ROUTER-OSPFv3
Usage
Information
The no version of this command resets the value to the default.
Example
OS10(config)# router ospfv3
OS10(config-router-ospfv3-100)# maximum-paths 1
Supported
Releases
10.3.0E or later
redistribute
Redistributes information from another routing protocol or routing instance to the OSPFv3 process.
Syntax
redistribute {bgp as-number | connected | static} [route-map route-map
name]
Parameters
● as-number — Enter an autonomous number to redistribute BGP routing information throughout the
OSPFv3 instance, from 1 to 4294967295.
● route-map name — Enter the name of a configured route-map.
● connected — Enter the information from the connected active routes on interfaces to redistribute.
● static — Enter the information from static routes on interfaces redistribute.
Defaults Not configured
556 Layer 3