Connectivity Guide

filepath}
running-configuration
OS10# copy scp://root:calvin@10.11.63.120/tmp/qaz.txt running-configuration
Restore startup configuration
The startup configuration file, startup.xml, is stored in the config system folder. To create a backup version, copy the
startup configuration to a remote server or the local config: or home: directories.
To restore a backup configuration, copy a local or remote file to the startup configuration and reload the switch. After
downloading a backup configuration, enter the reload command, otherwise the configuration does not take effect until you
reboot.
Copy file to startup configuration
OS10# copy {config://filepath | home://filepath |
ftp://userid:passwd@hostip/filepath | scp://userid:passwd@hostip/filepath |
sftp://userid:passwd@hostip/filepath | tftp://hostip/filepath} config://startup.xml
Back up startup file
OS10# copy config://startup.xml config://backup-9-28.xml
Restore startup file from backup
OS10# copy config://backup-9-28.xml config://startup.xml
OS10# reload
Back up startup file to server
OS10# copy config://startup.xml scp://userid:password@hostip/backup-9-28.xml
Restore startup file from server
OS10# copy scp://admin:admin@hostip/backup-9-28.xml config://startup.xml
OS10# reload
Reload system image
Reboot the system manually using the reload command in EXEC mode. You are prompted to confirm the operation.
OS10# reload
System configuration has been modified. Save? [yes/no]:yes
Saving system configuration
Proceed to reboot the system? [confirm yes/no]:yes
To configure the OS10 image loaded at the next system boot, enter the boot system command in EXEC mode.
boot system {active | standby}
● Enter active to load the primary OS10 image stored in the A partition.
● Enter standby to load the secondary OS10 image stored in the B partition.
Set next boot image
OS10# boot system standby
OS10# show boot
Current system image information:
===================================
Getting Started
51