Connectivity Guide

Configure BGP
OS10# configure terminal
OS10(config)# router bgp 100
OS10(config-router-bgp-100)# vrf blue
OS10(config-router-vrf)# neighbor 5.1.1.1
OS10(config-router-neighbor)# remote-as 1
OS10(config-router-neighbor)# description n1_abcd
OS10(config-router-neighbor)# exit
OS10(config-router-vrf)# template t1
OS10(config-router-template)# description peer_template_1_abcd
Configure Dual Stack
OS10 supports dual stack for BGPv4 and BGPv6. Dual stack BGP allows simultaneous exchange of same IPv4 or IPv6 prefixes
through different IPv4 and IPv6 peers. You can enable dual stack using the activate command in the corresponding address-
family mode. By default, activate command is enabled for the IPv4 address family for all the neighbors.
If a BGP-v4 neighbor wants to carry ipv6 prefix information, it activates the IPv6 address-family. For a BGP-v6 neighbor to
carry ipv4 prefix, it activates the IPv4 address-family.
1. Enable support for the IPv6 unicast family in CONFIG-ROUTER-BGP mode.
address family ipv6 unicast
2. Enable IPv6 unicast support on a BGP neighbor/template in CONFIG-ROUTER-BGP-AF mode.
activate
Configure administrative distance
Routers use administrative distance to determine the best path between two or more routes to reach the same destination.
Administrative distance indicates the reliability of the route; the lower the administrative distance, the more reliable the route. If
the routing table manager (RTM) receives route updates from one or more routing protocols for a single destination, it chooses
the best route based on the administrative distance.
You can assign an administrative distance for the following BGP routes using the distance bgp command:
● External BGP (eBGP) routes
● Internal BGP (iBGP) routes
● Local routes
If you do not configure the administrative distance for BGP routes, the following default values are used:
● eBGP—20
● iBGP—200
● local routes—200
To change the administrative distance for BGP, use the following command:
distance bgp external-distance internal-distance local-distance
Configure administrative distance
1. Enable BGP and assign the AS number in CONFIGURATION mode, from 0.1 to 65535.65535 or 1 to 4294967295.
OS10# configure terminal
OS10(config)# router bgp 100
2. Enter ADDRESS-FAMILY mode.
IPv4:
OS10(config-router-bgp-100)# address-family ipv4 unicast
OS10(configure-router-bgpv4-af)#
420
Layer 3