Connectivity Guide

------------------------------------------------------------------------------------------------------
1 ethernet1/1/1 remote-ip both port 11.11.11.1 11.11.11.11 0 255 35006 true Is UP
Example (all
sessions)
OS10# show monitor session all
S.Id Source Destination Dir Mode Source IP Dest IP DSCP TTL Gre-Protocol State Reason
------------------------------------------------------------------------------------------------------------
1 ethernet1/1/1 remote-ip both port 11.11.11.1 11.11.11.11 0 255 35006 true Is UP
9 ethernet1/1/9 both port N/A N/A N/A N/A N/A
7 ethernet1/1/9 vlan40 both port N/A N/A N/A N/A N/A
4 ethernet1/1/1 both port N/A N/A 0 255 35006 false
Destination is not resolved
6 ethernet1/1/2 remote-ip both port 11.11.11.1 2.2.2.1 0 255 35006 false Base
session does not exist
Supported
Releases
10.2.0E or later
shut
Disables the monitoring session. The monitoring session can be: local, RPM, or ERPM.
Syntax
shut
Parameters None
Default Disabled
Command Mode MONITOR-SESSION
Usage
Information
The no version of this command enables the monitoring session.
Example
OS10(config)# monitor session 1
OS10(conf-mon-local-1)# no shut
OS10(config)# monitor session 5 type rpm-source
OS10(conf-mon-rpm-source-5)# no shut
OS10(config)# monitor session 10 type erpm-source
OS10(conf-mon-erpm-source-10)# no shut
Supported
Releases
10.2.0E or later
source
Configures a source for port monitoring. The monitoring session can be: local, RPM, or ERPM.
Syntax
source interface interface-type {both | rx | tx}
Parameters
● interface-type — Enter the interface type:
○ ethernet node/slot/port[:subport] — Enter the Ethernet interface information as the
monitored source.
○ port-channel id-number — Enter the port-channel interface number as the monitored
source, from 1 to 128. This option is not supported in S5148F–ON .
○ vlan vlan-id —Enter the VLAN identifier as the monitored source, from 1 to 4093.
● both — Monitor both receiving and transmitting packets. This option is not supported in the
S5148F–ON platform, and on VLAN interfaces for other platforms.
● rx — Monitor only received packets.
● tx — Monitor only transmitted packets. This option is not supported in the S5148F–ON platform, and
on VLAN interfaces for other platforms.
Layer 2 369