Connectivity Guide

● DSCP: 0
Command Mode MONITOR-SESSION (ERPM)
Usage
Information
The no version of this command removes the configured TTL and DSCP values.
Example
OS10(conf-mon-erpm-source-10)# ip ttl 16
OS10(conf-mon-erpm-source-10)# ip DSCP 63
Supported
Releases
10.4.0E(R1) or later
monitor session
Creates a session for monitoring traffic with port monitoring.
Syntax
monitor session session-id type [local | rpm-source | erpm-source]
Parameters
● session-id — Enter a monitor session ID, from 1 to 18.
● local — (Optional) Enter a local monitoring session.
● rpm-source — (Optional) Enter a remote monitoring session.
● erpm-source — (Optional) Enter an encapsulated remote monitoring session.
Default local
Command Mode CONFIGURATION
Usage
Information
The no version of this command removes the monitor session.
Example
OS10(config)# monitor session 1
OS10(conf-mon-local-1)#
Example (RPM)
OS10(config)# monitor session 5 type rpm-source
OS10(conf-mon-rpm-source-5)#
Example (ERPM)
OS10(config)# monitor session 10 type erpm-source
OS10(conf-mon-erpm-source-10)#
Supported
Releases
10.2.0E or later
show monitor session
Displays information about a monitoring session.
Syntax
show monitor session {session-id | all}
Parameters
● session-id — Enter the session ID number, from 1 to 18.
● all — View all monitoring sessions.
Default All
Command Mode EXEC
Usage
Information
In the State field, true indicates that the port is enabled. In the Reason field, Is UP indicates that hardware resources are allocated .
Example
(specific
session)
OS10# show monitor session 1
S.Id Source Destination Dir Mode Source IP Dest IP DSCP TTL Gre-Protocol State Reason
368 Layer 2