Connectivity Guide

Parameters None
Default Not configured
Command Mode EXEC
Usage
Information
The counter default value resets to zero for all physical interfaces.
Example
OS10# clear lldp counters
Supported
Releases
10.2.0E or later
clear lldp table
Clears LLDP neighbor information for all interfaces.
Syntax
clear lldp table
Parameters None
Default Not configured
Command Mode EXEC
Usage
Information
Neighbor information clears on all interfaces.
Example
OS10# clear lldp table
Supported
Releases
10.2.0E or later
lldp enable
Enables or disables LLDP globally.
Syntax
lldp enable
Parameters None
Default Enabled
Command Mode CONFIGURATION
Usage
Information
This command enables LLDP globally for all Ethernet PHY interfaces, except on those interfaces where
you manually disable LLDP. The no version of this command disables LLDP globally irrespective of
whether you manually disable LLDP on an interface.
Example
OS10(config)# lldp enable
Supported
Releases
10.3.1E or later
lldp holdtime-multiplier
Configures the multiplier value for the hold time in seconds.
Syntax
lldp holdtime-multiplier integer
Parameters integer — Enter the holdtime-multiplier value in seconds, from 2 to 10.
Default 4 seconds
290 Layer 2