Connectivity Guide

Configure advertise TLVs
OS10(conf-if-eth1/1/3)# lldp tlv-select basic-tlv system-name
OS10(conf-if-eth1/1/1)# lldp tlv-select dot3tlv macphy-config max-framesize
OS10(conf-if-eth1/1/3)# lldp tlv-select dot1tlv link-aggregation
Network policy advertisement
LLDP-MED is enabled on all interfaces by default. Configure OS10 to advertise LLDP-MED TLVs from configured interfaces.
Define LLDP-MED network policies before applying the policies to an interface. Attach only one network policy per interface.
● Define an LLDP-MED network-policy on an interface in CONFIGURATION mode.
lldp-med network-policy {add | remove} number
○ add — Attach the network policy to an interface.
○ remove — Remove the network policy from an interface.
○ number — Enter a network policy index number, from 1 to 32.
Configure advertise LLDP-MED network policies
OS10(conf-if-eth1/1/5)# lldp-med network-policy add 1
Fast start repeat count
Fast start repeat count enables a network-connectivity device to advertise itself at a faster rate for a limited amount of time.
The fast start timer starts when a network-connectivity device receives the first LLDP frame from a newly detected endpoint.
When an LLDP-MED endpoint is newly detected or connected to the network, the lldp-med fast-start-repeat-count
command enables the network to quickly detect the endpoint. The LLDP-MED fast start repeat count specifies the number of
LLDP packets that send during the LLDP-MED fast start period. By default, the device sends three packets per interval. Change
the number of packets a device sends per second a maximum of 10.
Rapid availability is crucial for applications such as emergency call service location (E911).
● Enable fast start repeat count which is the number of packets sent during activation in CONFIGURATION mode, from 1 to
10, default 3.
lldp-med fast-start-repeat-count number
286
Layer 2