Connectivity Guide

Configure LLDPDU intervals
OS10(config)# lldp holdtime-multiplier 2
OS10(config)# do show lldp timers
LLDP Timers:
Holdtime in seconds: 60
Reinit-time in seconds: 2
Transmit interval in seconds: 30
Disable and re-enable LLDP
By default, LLDP is enabled for each interface and globally. You can disable LLDP on an interface or globally. If you disable LLDP
globally, LLDP is disabled on all interfaces irrespective of whether LLDP is previously enabled or disabled on an interface. When
you enable LLDP globally, the LLDP configuration in interface mode takes precedence over the global LLDP configuration.
1. Disable LLDPDU transmit or receive in INTERFACE mode.
no lldp transmit
no lldp receive
2. Disable LLDP holdtime multiplier value in CONFIGURATION mode.
no lldp holdtime-multiplier
3. Disable LLDP initialization in CONFIGURATION mode.
no lldp reinit
4. Disable LLDP MED in CONFIGURATION or INTERFACE mode.
no lldp med
5. Disable LLDP TLV in INTERFACE mode.
no lldp tlv-select
6. Disable LLDP globally in CONFIGURATION mode.
no lldp enable
Disable LLDP
OS10(config)# no lldp timer 100
OS10(config)# no lldp holdtime-multiplier 10
OS10(config)# no lldp reinit 8
Disable LLDP interface
OS10(config)# interface ethernet 1/1/4
OS10(conf-if-eth1/1/4)# no lldp med
OS10(conf-if-eth1/1/4)# no lldp tlv-select
OS10(conf-if-eth1/1/4)# no lldp transmit
OS10(conf-if-eth1/1/4)# no lldp receive
Enable LLDP
OS10(config)# interface ethernet 1/1/1
OS10(conf-if-eth1/1/1)# lldp transmit
OS10(conf-if-eth1/1/1)# lldp receive
Disable LLDP globally
OS10(config)# no lldp enable
284
Layer 2