Connectivity Guide

feature fc npg
Enables the NPG mode globally.
Syntax
feature fc npg
Parameters None
Defaults Disabled
Command Mode CONFIGURATION
Usage
Information
You can enable only one of the following at a time: F_Port, NPG, or FSB. The no version of this command
disables NPG mode.
Example
OS10(config)# feature fc npg
Supported
Releases
10.4.0E(R1) or later
show npg devices
Displays the NPG devices connected to the switch.
Syntax
show npg devices [brief]
Parameters None
Default Not configured
Command Mode EXEC
Usage
Information
Use the brief option to display minimum details.
Example
OS10# show npg devices
Enode[0]:
Enode MAC :d4:ae:52:1a:ee:54
Enode Interface: port-channel10(Eth 1/1/9)
FCF MAC :14:18:77:20:7c:e3
Fabric Interface :Fc 1/1/25
FCoE Vlan :1001
Vfabric Id :10
ENode WWPN :20:01:d4:ae:52:1a:ee:54
ENode WWNN :20:00:d4:ae:52:1a:ee:54
FCoE MAC :0e:fc:00:01:04:02
FC-ID :01:04:02
Login Method :FLOGI
Time since discovered(in Secs) :6253
Status :LOGGED_IN
Example (brief)
Total NPG Devices = 1
ENode-Interface ENode-WWPN FCoE-Vlan Fabric-Intf Vfabric-Id LoginMethod Status
-------------------------------------------------------------------------------------------------
Po 10(Eth 1/1/9) 20:01:d4:ae:52:1a:ee:54 1001 Fc 1/1/25 10 FLOGI
LOGGED_IN
Supported
Releases
10.4.0E(R1) or later
F_Port and NPG commands
The following commands are supported on both F_Port and NPG modes:
230
Fibre Channel