Connectivity Guide

Usage
Information
A default zone advertises a maximum of 255 members in the registered state change notification (RSCN)
message. The no version of this command disables access between the FC nodes in the absence of an
active zoneset.
Example
OS10(config)# vfabric 100
OS10(conf-vfabric-100)# zone default-zone permit
Supported
Releases
10.3.1E or later
zoneset activate
Activates an existing zoneset. You can activate only one zoneset in a vfabric.
Syntax
zoneset activate zoneset-name
Parameters zoneset-name — Enter an existing zoneset name.
Defaults Not configured
Command Mode Vfabric CONFIGURATION
Usage
Information
After you disable an active zoneset, the zone default-zone permit command configuration takes
effect. Based on this configuration, the default zone allows or denies access between all the logged-in FC
nodes of the vfabric. The no version of this command deactivates the zoneset.
Example
OS10(config)# vfabric 100
OS10(conf-vfabric-100)# zoneset activate set
Supported
Releases
10.3.1E or later
NPG commands
The following commands are supported on NPG mode:
fc port-mode F
Configures port mode on Fibre Channel interfaces.
Syntax
fc port-mode F
Parameters None
Defaults N_Port
Command Mode Fibre Channel INTERFACE
Usage
Information
Configure the port mode when the port is in Shut mode and when NPG mode is enabled. The no version
of this command returns the port mode to default.
Example
OS10(config)# interface fibrechannel 1/1/1
OS10(conf-if-fc1/1/1)# fc port-mode F
Supported
Releases
10.4.1.0 or later
Fibre Channel 229