Connectivity Guide

Defaults Not configured
Command Mode CONFIGURATION
Usage
Information
The no version of this command removes the FC zoneset.
Example
OS10(config)# fc zoneset set
OS10(conf-fc-zoneset-set)# member hba1
Supported
Releases
10.3.1E or later
feature fc
Enables the F_Port globally.
Syntax
feature fc domain-id domain-id
Parameters domain-id — Enter the domain ID of the F_Port, from 1 to 239.
Defaults Disabled
Command Mode CONFIGURATION
Usage
Information
The no version of this command disables the F_Port. You can disable the F_Port only when vfabric
and zoning configurations are not available. Before disabling the F_Port, remove the vfabric and zoning
configurations. You can enable only one of the following at a time: F_Port, NPG, or FSB.
Example
OS10(config)# feature fc domain-id 100
Supported
Releases
10.3.1E or later
member (alias)
Add members to existing FC aliases. Identify a member by an FC alias, a world wide name (WWN), or an FC ID.
Syntax
member {wwn wwn-ID | fc-id fc-id}
Parameters
● wwn-ID — Enter the WWN name.
● fc-id — Enter the FC ID name.
Defaults Not configured
Command Mode Alias CONFIGURATION
Usage
Information
The no version of this command removes the member from the FC alias.
Example
OS10(config)# fc alias test
OS10(config-fc-alias-test)# member wwn 21:00:00:24:ff:7b:f5:c9
OS10(config-fc-alias-test)# member wwn 20:25:78:2b:cb:6f:65:57
Supported
Releases
10.3.1E or later
member (zone)
Adds members to existing zones. Identify a member by an FC alias, a world wide name (WWN), or an FC ID.
Syntax
member {alias-name alias-name | wwn wwn-ID | fc-id fc-id}
224 Fibre Channel