Connectivity Guide

Figure 4. S4148U-ON unified port groups
To enable Ethernet interfaces in a unified port group:
1. Configure a unified port group in CONFIGURATION mode. Enter 1/1 for node/slot. The port-group range depends on the
switch.
port-group node/slot/port-group
2. Activate the unified port group for Ethernet operation in PORT-GROUP mode. To activate a unified port group in Fibre
Channel mode, see Fibre Channel interfaces. The available options depend on the switch.
mode Eth {100g-1x | 50g-2x | 40g-1x | 25g-4x | 10g-4x}
● 100g-1x — Reset a port group to 100GE mode.
● 50g-2x — Split a port group into two 50GE interfaces.
● 40g-1x — Set a port group to 40GE mode for use with a QSFP+ 40GE transceiver.
● 25g-4x — Split a port group into four 25GE interfaces.
● 10g-4x — Split a port group into four 10GE interfaces.
3. Return to CONFIGURATION mode.
exit
4. Enter Ethernet Interface mode to configure other settings. Enter a single interface, a hyphen-separated range, or multiple
interfaces separated by commas.
interface ethernet node/slot/port[:subport]
Configure Ethernet unified port interface
OS10(config)# port-group 1/1/13
OS10(conf-pg-1/1/13)# mode Eth 25g-4x
OS10(conf-pg-1/1/13)# exit
OS10(config)# interface ethernet 1/1/41:1
OS10(conf-if-eth1/1/41:1)#
View Ethernet unified port interface
OS10(config)# interface ethernet 1/1/41
OS10(conf-if-eth1/1/41:1)# show configuration
!
interface ethernet1/1/41:1
no shutdown
Z9264F-ON port-group profiles
On the Z9264F-ON switch, the port-group profiles determine the available front-panel Ethernet ports and supported breakout
interfaces. QSFP28 ports operate only in Ethernet mode. Use the port-group profile to configure breakout interfaces and
specify the port speed.
140
Interfaces