Connectivity Guide

Parameters
● vrf vrf-name — (Optional) Enter vrf and then the name of the VRF to configure the domain
corresponding to that VRF.
● server-name — (Optional) Enter the server name the default domain uses.
Default Not configured
Command Mode CONFIGURATION
Usage
Information
This domain appends to incomplete DNS requests. The no version of this command returns the value to
the default.
Example
OS10(config)# ip domain-name jay dell.com
Supported
Releases
10.2.0E or later
ip host
Configures mapping between the host name server and the IP address.
Syntax
ip host [vrf vrf-name] [host-name] address
Parameters
● vrf vrf-name — (Optional) Enter vrf and then the name of the VRF to configure the name server
to IP address mapping for that VRF.
● host-name — (Optional) Enter the name of the host.
● address — Enter an IPv4 or IPv6 address of the name server in A.B.C.D or A::B format.
Default Not configured
Command Mode CONFIGURATION
Usage
Information
The name-to-IP address table uses this mapping information to resolve host names. The no version of
this command disables the mapping.
Example
OS10(config)# ip host dell 1.1.1.1
Supported
Releases
10.2.0E or later
ip name-server
Configures up to a three IPv4 or IPv6 addresses used for network name servers.
Syntax
ip name-server ip–address [ip-address2 ip-address3]
Parameters
● ip–address — Enter the IPv4 or IPv6 address of a domain name server to use for completing
unqualified names (incomplete domain names that cannot be resolved).
● ip–address2 ip-address3 — (Optional) Enter up two additional IPv4 or IPv6 name servers,
separated with a space.
Default Not configured
Command Mode CONFIGURATION
Usage
Information
OS10 does not support sending DNS queries over a VLAN. DNS queries are sent out on all other
interfaces, including the Management port. You can separately configure both IPv4 and IPv6 domain
name servers. In a dual stack setup, the system sends both A (request for IPv4) and AAAA (request for
IPv6) record requests to a DNS server even if you only configure this command. The no version of this
command removes the IP name-server configuration.
Example
OS10(config)# ip name-server 10.1.1.5
Supported
Releases
10.2.0E or later
System management 137