Connectivity Guide

Defaults None
Command Mode EXEC
Usage
Information
To send the tar file to Dell EMC Technical Support, use the dir supportbundle
and copy supportbundle://sosreport-OS10-file-number.tar.gz tftp://server-
address/path commands.
Example
OS10# generate support-bundle
Example (Enable
Options)
OS10# generate support-bundle enable-all-plugin-options
Supported
Releases
10.2.0E or later
System monitoring
Monitor OS10 using system alarms and log information.
System alarms
Alarms alert you to conditions that might prevent normal device operation:
● Critical — A critical condition exists and requires immediate action. A critical alarm may trigger if one or more hardware
components fail, or one or more hardware components exceeds temperature thresholds.
● Major — A major error occurred and requires escalation or notification. For example, a major alarm may trigger if an
interface failure occurs, such as a port-channel being down.
● Minor — A minor error or non-critical condition occurred that, if left unchecked, might cause system service interruption or
performance degradation. A minor alarm requires monitoring or maintenance.
● Informational — An informational error occurred but does not impact performance. Monitor an informational alarm until the
condition changes.
Triggered alarms are in one of these states:
● Active — Alarms that are current and not cleared.
● Cleared — Alarms that are resolved and the device has returned to normal operation.
System logging
You can change the system logging default settings using the severity level to control the type of system messages that log.
The range of logging severities are:
● log-emerg — System is unstable.
● log-alert — Immediate action needed.
● log-crit — Critical conditions.
● log-err — Error conditions.
● log-warning — Warning conditions.
● log-notice — Normal but significant conditions, the default.
● log-info — Informational messages.
● log-debug — Debug messages.
● Enter the minimum severity level for logging to the console in CONFIGURATION mode.
logging console severity
● Enter the minimum severity level for logging to the system log file in CONFIGURATION mode.
logging log-file severity
Troubleshoot OS10
1131