Owner's Manual

Introduction 11
Using the Configuration Utility
To use the configuration utility:
1
Launch the command prompt on the management server.
2 Navigate to DellSPIConfigUtility.exe . The default location is C:\Program
Files\Dell\OpenManage Connection for HP.
3 Type the following command:
DellSPIConfigUtility.exe -<option>=<value> and press
Enter .
For example, if you want to set the WSMAN timeout, type the following
command:
DellSPIConfigUtility.exe -wsmantimeout=500
NOTE: If you enter invalid values, the utility displays the error message with
the help text.
If you do not specify new values for any of the options, the utility uses the
default values. However, you must set the values for wsmanusername and
wsmanpassword if you are monitoring the ESXi systems. You must also set
the value for the DWS URL.
When you specify the value for wsmanpassword, type the following command
DellSPIConfigUtility.exe -wsmanpassword and press Enter.
You do not need to specify = after -wsmanpassword. When you specify the
-getall Specifies the values of all the options and display
them on the screen. This option gets all the values for
all the individual parameters except wsmanusername
and wsmanpassword.
-resetdefaults Resets all the configurable values to the default
values.
NOTE: This option does not reset the values for the -
wsmanusername and -wsmanpassword options.
-help Displays the help for using this tool.
Table 1-3. Command Line Options
Option Description
DellSPIv2.0_QIG.book Page 11 Thursday, March 3, 2011 2:13 PM